Logo Facebook   Logo Youtube   Logo LinkedIn   Link Imprint Page
A brand of Luca Industries International GmbH
application machinery

LithoPore® - Cutting Machine SM20

LithoPore® - Cutting Machine SM20
award
  • Fully automated cutting process
  • Manual mould handling
  • Low investment
  • For stationary use
  • For a professional start

LithoPore® Cutting Machine SM20 is specifically engineered for block making. It contains only one cutting tower, that is performing the following steps:

  • Top and bottom cut (horizontal cutting)
  • Longitudinal cut (vertical cutting)
  • Transversal cut (vertical cutting)
The machine works fully automated. LithoPore® Aerated Concrete – LPAC is poured into LithoPore® Moulds and is hardening within around 5-12 hours depending on temperature, humidity as well as mix design of the product itself. The Mould sides will be removed and the large block remains on LithoPore® Basement. It will be manually pushed into the LithoPore® Cutting Machine SM20. The machine starts doing the top and bottom cut as well as the vertical cuts in one direction. After that the mould basement with cut block pieces has to be pulled out, turned by 90°C and again pushed back into the machine. The remaining cuts will be done by the machine again fully automated. As the machine is equipped with one single wire only, the capacity is limited. The machine can be upgraded later on to SM100 or SM150 type. Most of its components can be used for this upgrade.
  Entity SM20 SM100 SM150
LPAC capacity per mould [l] 864 864 864
Mould quantity per hour [pieces/h] 3 - 4 6 - 12 10 - 13
LPAC capacity per hour [m³/h] 2.25 - 3.5 5.0 - 10.5 8.5 - 11.2
Effective Capacity   depends on block dimensions depends on block dimensions independently of block dimensions
Density range [kg/m³] 100 - 800 100 - 800 100 - 800
Power requirements [kW]
[V]
[Hz]
 
400
50/60
 
400
50/60
 
400
50/60
Cutting waste [%] 6 - 7 6 - 7 6 - 7
×
< >